As mentioned in last month’s article, CASSETTE RECORDING INFORMATION, problems exist in trying to make good copies of programs from a computer. If you have tried all the hints mentioned in that article and still have problems, the reason usually lies in one of two areas.
If a program was recorded from a computer other than your own or from computer duplicating equipment and loads OK, but programs that were produced from your own computer do not load easily, it could be because:
1 – The internal circuitry of the computer that controls the saving of the programs is defective. This is not usually the case but can happen. Since the programs that were produced from an outside source load all right, the programs you try to save can be recorded with various degrees of improper data pulses. Before blaming the problem on the computer, first investigate the procedures that follow.
2 – The computer and/or cassette recorder are picking up excess noise from their Alternating Current power sources in the form of power spikes. These are caused by electrical machinery, fluoresent fixture transformers, arc welders, refrigerators, air compressors, air conditioners, etc.
If you have the type of recorder that can be run by batteries, remove the AC power cord and insert the proper batteries. Write a short program and then save it on cassette. Try to reload it and see if this helps. It should make no difference if the recorder is on AC or DC when you are loading the program back into the computer. Some recorders may however have a problem keeping the drive motor operating at a constant RPM when they are powered by pure DC current from batteries, so make sure the batteries are fresh.
If this does not help, then the DC power input into the computer may be the culprit. There are different methods of achieving this. The problem may be the 9-VDC power supply itself but again this is not usually the case. The power supply can be filtered by an inexpensive FILTERED AC POWER SUPPLY such as the type sold by RADIO SHACK (part #15-1110 6.95).
The SINCLAIR 9-VDC power supply would be plugged into the filtered AC power supply. Now try saving a sample program and see what happens.
Using either or both of these methods will usually solve the problem. If it doesn’t, there is one other method I have tried that worked just fine. I replaced the 9-VDC power source for the computer with a 9-VDC battery such as the EVEREADY #276, the RAY-O-VAC #1603 or the DURACELL #M1603. Of course the proper electrical connector had to be built. I used the ready built type sold by RADIO SHACK that has the miniature phono plug on one end of a cord and 2 wire leads with alligator clips on the other end
CAUTION – OBSERVE PROPER POLARITY when using this method. The alligator clip that has continuity (connects) with the metal tip of the phono plug goes to the POSITIVE side of the battery. If you have any uncertainty or doubts as to this hookup, ask someone who has some expertise in this area to do it for you. IMPROPER POLARITY MAY CAUSE DAMAGE TO THE COMPUTER
Fortunately, the CRT (TV) does not have to be turned off while you are saving a program because it imparts no electrical input to the computer.
If you have experienced any problems with the computer, 16K RAM pack or with recording that you have or have not solved, please send us a letter and we will pass it on to the readers.